CS-Alarmsystem "Furie" incl. 2 cartridges

 Save your belongings with CS-gas (teargas) against burglary and other accesses.

To assemble the Furie an existent alarm device or a switch for manual activating is required.

Potential application for the CS-gas system are e.g.:
Buildings: houses, bureaus, cellars, garages etc.
Defence: for cashpoints, taxi, doorways, night desk etc.
Vehicles: cars, busses, motor camp, caravan etc.
Also suited for: boats, automatons, camping, lockbox etc.

The CS-gas guard system attend your personal defence at an extension for your existing alarm device. The combination attain an activ coverage for diverse rooms or devices.

This system is easy to combine and install with almost all commercial alarm devices.

Installation:
a) If you want to affix the CS-gas system behind a carpeting, then you should use the included tube for laying the flow point in the middle of the room. Therefor you impose the tube on the connector, before you affix the cartridge.

b) Affix the activating system vertical with the flexes down at the intended place. The system should not be visible for the intruder and at the same time it should be childproof. Choose a place near by the alarm device (conditional by the length of the cable – extensions up to 3 metres are possible).

The kind of fixing is variable as the condition of the room. Recommendable is the application with a rigid bracket (not included by delivery).

c) The flex from the CS-gas cartridge is connected with the alarm device. The polarity at the connectors are irrelevant. You need a power source with min. 12 V and min. 3 A for a save activating.

TIP: Becoming the activating system and the alarm device combined, suit the connector for the alarm siren perfectly.
ATTENTION! When electricity connected, gas is flowing!

d) Lay the tube at the suitable place in the room. Do not break or compress the tube! The application under one meter distance bring damage caused to you health!

e) Now is the previous alarm device adjusted and by an activating parallel the signal will the cs-gas flow into the room, if you install the device accordant.

f) Please affix the sticker with the warning visible on the door oder window, before you become liable.

An exception results from alarm devices, which sounded by activation and deactivation. In that case you need accessorily release delay for the CS-gas system.

Exchanging the CS-gas cartridge
Turn the screwtop up from the system. Change the cartridge and close it. For avoidance a faulty activation, please apply the locking pin.

Neutralisation
After activating by the alarm device it is easy to remove the CS-gas with neutraliser, which we sell also in our shop